Unsupported Browser
The web browser that you are currently using is no longer supported, and as such features of this website may not work as expected. We advise you to update to a currently supported browser (such as Chrome, Edge, or Firefox) to improve your security, speed, and overall experience.
This product is currently unavailable for delivery to your country
Key Features
Product Ref: 314394
The CD11 is the result of a collaboration between Rotel and audio legend Ken Ishiwata. Ishiwata used to work with Marantz for decades as an engineer. After parting ways with Marantz, Ishiwata worked alongside Rotel to design some HiFi components. The CD11 being one of the last ones before he passed away. This shows a lot of his design philosophies with the component changes as well as the idea that a CD player should just play CDs.
The digital to analogue conversion is done using a Texas Instruments 24-bit 192kHz DAC. This is the same company that produces Burr Brown DACs so you can be assured that this is of exquisite quality. Eight capacitors and one resistor in this DAC have been upgraded to provide the best quality. As have all nine of the capacitors in the PSU for extra performance. Additionally, the electrical ground paths have had their routings altered.
With RCA analogue outputs you can send the signal from this CD player to an amplifier of your choice and distribute the signal throughout your system. A digital coaxial out also enables you to send the audio signal to an external DAC if you have a dedicated unit in your setup. The 12v Trigger and RS232 plugs on the CD11 also enable you to access some remote control functionalities so you can have your whole system's control centralised.
Total Harmonic Distortion + Noise | 0.005 @ 1k Hz |
---|---|
Intermodulation Distortion | 0.005 @ 1k Hz |
Frequency Response (± 0.5 db) | 20-20,000 Hz |
Channel Balance | ± 0.5 dB |
Phase Linearity | ± 0.5 degree |
Channel Separation | > 115 dB @ 10k Hz |
Signal to Noise Ratio (“A” weighting) | > 125 dB |
Dynamic Range | > 99 dB |
Digital to Analog Converters | Texas Instruments |
Analog Output Impedance | 470 Ohms |
Digital Output | 0.5 Volt, Peak to Peak |
Load Impedance | 75 Ohms |
GeneralPower Requirements (AC) | 230 V, 50 Hz |
Power Consumption | 15 watts |
Standby Power Consumption | < 0.5 watts |
BTU | 40 BTU/h |
Finishes | Silver and Black |
Dimensions (W x H x D) | 430 x 98 x 314 mm 17" x 3 7/8" x 12 3/8" |
Front Panel Height | 80 mm, 3 1/8" |
Weight (net) | 5.8 kg, 12.7 lb |